Filter
Top Products
OPERATION
B-25 B-25
POWER FEED® 25M
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
SET-UP FEATURES MENU
The Setup Menu gives access to the set-up configura-
tion. Stored in the set-up configuration are user para-
meters that generally need to be set only at installation.
The parameters are grouped as follows:
• P.1 through P.99 Unsecured Parameters (always
adjustable)
• P.101 through P.199 Diagnostic Parameters (always
read only)
• P.501 through P.599 Secured Parameters (accessi-
ble only though a p.c. or palm application.)
To access the set-up menu, press the right and left but-
tons of the MSP4 panel simultaneously. Note that the
set-up menu cannot be accessed if the system is weld-
ing, or if there is a fault (The status LED is not solid
green).
Change the value of the blinking parameter by rotating
the SET knob.
After changing a parameter it is necessary to press the
right hand button to save the new setting. Pressing the
left button will cancel the change.
To exit the set-up menu at any time, press the right and
left buttons of the MSP4 panel simultaneously.
Alternately, 1 minute of inactivity will also exit the set-
up menu.
The following list includes all possible parameters
in ArcLink® equipment. Not all of the parameters
listed may appear for your system. Refer to Table
B.1 for active parameters.
PARAMETER
P.0
P.1
P.2
P.4
P.5
P.6
P.7
P.8
P.11
P.12
P.13
P.80
P.99
DESCRIPTION
Exit set-up menu
WFS Units
Arc Display Mode
Trigger Memory Recall
Trigger Procedure Change
Stall Factor Adjustment
Gun Offset Adjustment
TIG Gas Control
Set Timers
Travel Options
Adjust Arc Force
Sense From Studs
Show Test Modes
View Diagnostics
View Event Logs
View Fatal Logs
View Software Version
View Hardware Version
View Welding Software
View Ethernet IP Address
View Power Source Type
P.100
P.101
P.102
P.103
P.104
P.105
P.106
P.107
Unsecured Parameters
Diagnostic Parameters
POWER FEED®
10M (All Models)
POWER
FEED® 10A
POWER
FEED® 25M
TABLE B.1