Miele 09 898 020 Welding System User Manual


 
Frequently asked questions
134
Problem Possible cause and solution
In the burner display
the symbol will flash
alt
ernately with the
selected power setting
or .
There is no or unsuitable cookware on the burner.
Use a suitable pan (see "P
ans").
After the cooktop is
turned on,  appears in
the display for a few
seconds.
The system lock has been activated.
Deac
tivate the system lock (see "Cooktop safety
features").
After switching the
cooktop on, .
appears in the display
for several seconds.
The burners do not heat
up.
Demonstration mode is activated.
T
urn the knob for the front left burner to the left
and hold it.
T
urn the knob for the front right burner twice
quickly to the left and then to the left until 
appears in the display.
A burner switches itself
off aut
omatically.
A burner might have been operated for too long.
Y
ou can use the burner again by switching it back
on (see "Safety switch-off").
The booster has
aut
omatically switched
off early.
The overheat protection was triggered.
See "O
verheat protection".
The burner is not
working in the usual
way with the set power
level.
The overheat protection was triggered.
See
"Overheat protection".
Power setting 9 is
aut
omatically reduced if
you select power
setting 9 on two linked
burners or extended
zones at the same time.
Operating both zones at power level 9 would exceed
the permitt
ed maximum power for the cooktop.
U
se another burner that is not linked.
AutoBoost is turned on,
but the food does not
star
t cooking.
Large amounts of food are being heated.
S
tart cooking at the highest power level, then
reduce the power level manually.
The pan is not conducting heat properly.
Use a differ
ent pan that is able to better conduct
heat on an induction cooktop.