Filter
Top Products
OUTLINE
6
1.3.3 Removal and reinstallation of the operation panel
To ensure safety, remove and reinstall the operation panel after switching power off.
•
Removal
Hold down the top button of the operation panel and pull the operation panel toward you to remove.
!
Removal
!
Reinstallation
To reinstall, insert straight and mount securely.
•
Reinstallation using the connection cable
1) Remove the operation panel.
2) Disconnect the modular jack type relay connector. (Place the disconnected modular jack type relay
connector in the modular jack type relay connector compartment.)
Modular jack type relay connector compartmen
t
Modular jack type relay connector
3) Securely plug one end of the connection cable into the PU connector (modular jack type relay
connector) of the inverter and the other end into the operation panel.
(For the connection cable, refer to 22 page.)
Note: Install the operation panel only when the front cover is on the inverter.
1