Filter
Top Products
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
7-24 Virtual Private Networking Using IPsec Connections
v1.0, September 2009
To add or edit an IKE policy, see “Manually Adding or Editing an IKE Policy on this page.
Manually Adding or Editing an IKE Policy
To manually add an IKE policy:
1. Select VPN > IPSec VPN from the menu. The IPsec VPN submenu tabs appear with the IKE
Policies screen in view (see Figure 7-20 on page 7-23).
2. Under the List of IKE Policies table, click the add table button. The Add IKE Policy screen
displays (see Figure 7-21 on page 7-25, which shows the UTM25 screen). The WAN1 and
WAN2 radio buttons (next to Select Local Gateway) are shown on the Add IKE Policy screen
for the UTM25 but not on the Add IKE Policy screen for the UTM10.
Note: You cannot delete or edit an IKE policy for which the VPN policy is active. You
first must disable or delete the VPN policy before you can delete or edit the IKE
policy.
Note: To gain a more complete understanding of the encryption, authentication and
DH algorithm technologies, see the link to “Virtual Private Networking Basics” in
Appendix E.