Filter
Top Products
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
Network and System Management 10-11
v1.0, September 2009
3. Select the Check to Edit Password checkbox. The password fields become active.
4. Enter the old password, enter the new password, and then confirm the new password.
5. As an option, you can change the idle timeout for an administrator login session. Enter a new
number of minutes in the Idle Timeout field. (The default setting is 5 minutes.)
6. Click Apply to save your settings.
7. Repeat step 1 through step 6 for the user with the name ‘guest’.
You can also change the administrator login policies:
• Deny login access from a WAN interface. By default, the administrator can log in from a WAN
interface.
• Deny or allow login access from specific IP addresses. By default, the administrator can log in
from any IP address.
• Deny or allow login access from specific browsers. By default, the administrator can log in
from any browser.
In general, these policy settings work well for an administrator. However, if you need to change
any of these policy settings, see “Setting User Login Policies” on page 9-12.
Note: The ideal password should contain no dictionary words from any language, and
should be a mixture of letters (both upper and lower case), numbers, and
symbols. Your password can be up to 30 characters.
Note: After a factory default reset, the password and timeout value are changed back
to password and 5 minutes, respectively.
Note: For enhanced security, restrict access to as few external IP addresses as
practical.