Filter
Top Products
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
2-8 Using the Setup Wizard to Provision the UTM in Your Network
v1.0, September 2009
Setup Wizard Step 1 of 10: LAN Settings
Enter the settings as explained in Table 2-1 on page 2-9, then click Next to go the following
screen.
Figure 2-7
Note: In this first step, you are actually configuring the LAN settings for the UTM’s
default VLAN. For more information about VLANs, see “Managing Virtual LANs
and DHCP Options” on page 4-1.
Note: After you have completed the steps in the Setup Wizard, you can make changes to
the LAN settings by selecting Network Config > LAN Settings > Edit LAN
Profile. For more information about these LAN settings, see “VLAN DHCP
Options” on page 4-4.