Filter
Top Products
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
7-32 Virtual Private Networking Using IPsec Connections
v1.0, September 2009
To delete one or more VPN polices:
1. Select the checkbox to the left of the policy that you want to delete or click the select all table
button to select all VPN policies.
2. Click the delete table button.
To enable or disable one ore more VPN policies:
1. Select the checkbox to the left of the policy that you want to delete or click the select all table
button to select all IKE Policies.
2. Click the enable or disable table button
To add or edit a VPN policy, see “Manually Adding or Editing a VPN Policy” on this page.
Manually Adding or Editing a VPN Policy
To manually add a VPN policy:
1. Select VPN > IPSec VPN from the menu. The IPsec VPN submenu tabs appear with the IKE
Policies screen in view (see Figure 7-20 on page 7-23).
2. Click the VPN Policies submenu tab. The VPN Policies screen displays (see Figure 7-22 on
page 7-31).
3. Under the List of VPN Policies table, click the add table button. The Add VPN Policy screen
displays (see Figure 7-23 on page 7-33, which shows the UTM25 screen). The WAN1 and
WAN2 radio buttons (next to Select Local Gateway) are shown on the Add VPN Policy screen
for the UTM25 but not on the Add VPN Policy screen for the UTM10.
Encr The encryption algorithm that is used for the VPN tunnel. This setting must
match the setting on the remote endpoint.
Action An edit table button allows you to access an individual policy to make changes.
Note: You cannot delete or edit an IKE policy for which the VPN policy is active. You
first must disable or delete the VPN policy before you can delete or edit the IKE
policy.
Table 7-11. List of VPN Policies Information (continued)
Item Description (or Subfield and Description)