Filter
Top Products
10
EGX-20 USER'S MANUAL
EG
X-20
Attaching the Adhesive Sheet
You use the included adhesive sheet to secure material to engrave to the table on the EGX-20.
First you need to install the included adhesive sheet on the table.
EG
X-20
NOTICE
Be sure the unit is in View status when attaching the adhesive sheet.
There are holes at the four corners of the table.
Align the corner of the adhesive sheet with the lower-left
hole.
Table
Carriage
Adhesive sheet
Table
adhesive sheet
1
Press the power button on the EGX-20 to turn on the
power.
The carriage moves to the right edge and the table moves
to the front, the unit goes into View status, and the Power
and View lights light up.
2
Peel off the protective paper from both sides of the
adhesive sheet.
3
Place the adhesive sheet on the table as shown in the
figure at right, press down on it from above, and secure it
in place so that it will not peel off.
1
2
3