Filter
Top Products
41
6 Other Information
Replacement Cutters and Consumable Parts
The following replacement blades and consumable parts are available.
Replacement Cutters (Diameter 3.175 mm and Length 114 mm)
General-purpose (general-purpose cutters suitable for engraving acrylic and plastic plates)
No. Blade width
• ZEC-A2013 0.127 mm
• ZEC-A2025 0.254 mm (* This is the originally included blade.)
• ZEC-A2051 0.508 mm
• ZEC-A2076 0.762 mm
Flat cutter (blades having a wider tip than general-purpose cutters)
No. Blade width
• ZEC-A2150 1.52 mm
• ZEC-A2190 1.91 mm
• ZEC-A2230 2.29 mm
• ZEC-A2320 3.175 mm
Quarter-round types (having a larger tip pocket than general-purpose cutters, and suited to
engraving soft material at high speed)
No. Blade width
• ZEC-A2013-QR 0.13 mm
• ZEC-A2025-QR 0.25 mm
Adhesive Sheet
No. Specification
• AS-10 210 mm x 140 mm, 10 sheets
Replacement Spindle-motor Unit
As a general guide, we recommend replacing this after every 1,000 hours.
Daily Care and Maintenance
• Use a vacuum cleaner to carefully clean away cutting dust.
• Use a toothbrush or the like to remove cuttings from the adhesive sheet.
• Do not use an air blower or the like to blow away cutting dust. The cuttings may get inside the machine and cause breakdown.
• Use a dry or well wrung-out cloth to wipe clean. Do not use solvents such as thinner or alcohol.
• Lubrication is not required. Improper application of grease or the like may actually lead to breakdown and should not be attempted.
6 Other Information