Filter
Top Products
11
1 Getting Ready
The cutter holder is reverse-threaded.
Turn it counterclockwise to tighten.
Installing the Cutter Holder
Before you install a cutter, you need to install the included cutter holder on the spindle unit.
Cutter
Cutter holder
Open the cover for the carriage.
1
A cutter holder is attached to the included cutter.
Remove the cutter from the cutter holder.
2
Open the cover for the carriage.
Orient the cutter holder so that the screw is underneath,
insert the cutter holder into the spindle unit from above,
then turn the cutter holder counterclockwise by hand to
secure it in place.
The spindle unit moves when you do this, so insert the
included hexagonal screwdriver into the hole in the
spindle unit as shown in the figure to keep it from
moving.
1
2
3