Filter
Top Products
18
EGX-20 USER'S MANUAL
Insert the cutter into the hole in the cutter holder, then
slowly lower the cutter.
Lower until the cutter touches the plate.
Use the included hexagonal screwdriver to tighten the
retaining screw for the cutter holder.
Tighten secure so that the cutter does not come loose
during engraving.
Press the Origin Set button on the switch panel.
The spindle unit rises 0.5 mm and the Origin Set light
goes dark.
Before you install a cutter, install the cutter holder.
See --> p. 11 "Installing the Cutter Holder"
NOTICE
6
7
8