Filter
Top Products
16
EGX-20 USER'S MANUAL
Place the plate on the adhesive sheet, then press down on
it from above to anchor it securely.
You can place the item anywhere on the adhesive sheet.
However, if the plate is placed at an angle with respect to
the table, the engraving will not be straight.
Place it so that it is aligned straight with the corners and
sides of the table.
If the EGX-20 is switched off, press the power button to
turn it on.
The carriage moves to the right edge and the table moves
to the front, the unit goes into View status, and the Power
and View lights light up.
If the EGX-20 is turned on but the View light is not
illuminated, press the View button.
The carriage moves to the right edge and the table moves
to the front, the unit goes into View status, and the Power
and View lights light up.
3 Creating a Nameplate (Operations in the Engraving Mode)
EGX-20
This section describes the basic steps for engraving using the EGX-20, taking the procedure for engraving the plate included
with the machine as an example.
Loading Material
You use the included adhesive sheet to secure material to engrave to the table on the EGX-20.
Before you load material, attach the included adhesive sheet.
See --> p. 10 "Attaching the Adhesive Sheet"
Be sure the unit is in View status when loading material.
NOTICE
Power and View
lights illuminated
Place the plate on the adhesive sheet,
then press down on it from above to
anchor it securely.
1
2