Filter
Top Products
27
3 Creating a Nameplate (Operations in the Engraving Mode)
Performing Engraving
Now Let's try engraving a name on a plate.
If the View light on the EGX-20 is illuminated, press the View button to make the View light go dark.
At the toolbar, click
.
Alternatively, go to the [File] menu and select [Print].
The [Print Setup] dialog box appears.
Make sure the printer name is set to [Roland EGX-20] (if the printer name is not [Roland EGX-20], then click the drop-down
arrow and select [Roland EGX-20]), then click [OK].
Cutting starts.
When engraving ends, the spindle unit rises all the way to the top and stops there.
Then, remove the material, press the View button.
The carriage moves to the right edge and the table moves to the front, allowing you to detach the material from the adhesive
sheet.
Use a toothbrush or the like to carefully brush away any buildup of cuttings on the material or the adhesive sheet.
Also, use a vacuum cleaner to carefully clean away any cuttings remaining on the EGX-20.
Emergency Stop
If some problem occurs while engraving is in progress and you want to stop the EGX-20, follow the steps below.
Press the power button on the switch panel.
If there is a printer icon on the taskbar in Windows, double-click the icon.
The progress of printing is displayed. Delete the document.
3
2
1
1
2