Filter
Top Products
15
2 Getting Ready the Software
The setup screen ([Welcome] dialog box) appears for the
next program to install.
Carry out steps through on the previous page.
Install Dr. Engrave and 3D Engrave.
When installation of 3D Engrave finishes, the [EGX-20
Driver Installation] dialog box appears.
Choose the port for connecting the EGX-20.
The EGX-20 connects to a printer port. If your computer
has a single printer port, select [LPT1:].
Click [OK].
The EGX-20 driver is installed.
When installation of the EGX-20 driver finishes, the
[Settings: [EGX-20]] dialog box appears.
Make sure the values are correct, then click [Close].
When all installation and setup finishes, a prompt dialog
box appears. Click [Close].
When the setup menu screen reappears, click the
button.
Take the CD-ROM out of the CD-ROM drive.
10
11
12
13
14
15
6 9