Filter
Top Products
Accessing Storage Devices
4-4 Interface to Standalone Drives 6-00025-01 Rev A
• Basic ASCII terminal
Normally, the interface is run from one window or terminal
while AMASS is run from another window or terminal.
To run the Standalone Operator Interface, follow the steps
below:
Step 1. Log in as amass.
Step 2. Enter the following command:
Step 3. Load a volume into a specific drive per instructions
from the interface prompt. The prompt always
specifies a volume number, a volume side, and the
volume label.
For example, if a request requires you to load side A
of volume number 2, text similar to the following
appears:
Step 4. Use <Control-C> to exit the interface.
# sysop
***** OPERATOR LOAD VOLUME REQUEST *****
Please load VOLUME NUMBER 2,
SIDE A,
LABEL datavolume 2
into JUKEBOX #2 DRIVE #1 after VOLUME has
been loaded, press return
or IF INCORRECT VOLUME enter eject
or TO ABORT REQUEST enter abort
Press RETURN when LOADED: