Filter
Top Products
Accessing Storage Devices
6-00025-01 Rev A Connectivity and Media Preparation 1-13
Unload Media
4 volstat Mark the volumes “Active” in the AMASS
database
Active = allows AMASS to read and/or
write to media
* Otherwise, use the bulkload command if you: (1) Already have
media residing in the library. Typically, this happens when you install
AMASS at a site that already has volumes in an existing library. (2)
Load media manually, without using the mailbox.
Step Command Description
Step Command Description
1 bulkoutlet
See following
NOTE.
Unload media through mailbox. Mark
specified volumes “Offline” in the AMASS
database.
Offline = media is
out
of storage device
2 volstat Mark the volumes “Inactive” in the
AMASS database.
Inactive = AMASS
cannot
read and/or
write to media
NOTE: To unload just one piece of media through the mailbox and
mark it “Offline” in the AMASS database, you can also use the
voloutlet command.