Filter
Top Products
Accessing Storage Devices
2-8 Library List 6-00025-01 Rev A
Load and Unload Tape
Use the volloc command and mediamove utility to load and
unload media in the libraries; exceptions are noted below. For
instructions, see “Prepare Media for Network Devices” on
page 1-11. For information on this utility, refer to the Utility
Reference chapter in Managing the AMASS File System.
Load Tape into Scalar
For instruction on preparing media for use by AMASS, see
either:
“Prepare Media for SCSI Devices” on Page 1-8.
“Load Media into Multislot Mailbox” on Page 1-10.
Step 1. Load media using the volinlet command.
Step 2. Load media into the mailslot so the barcode for side
A is nearest to the top.
Top of Mailslot
Side A
4
5
C
7
8
B
4
5
C
7
8
A