Filter
Top Products
Commands by Subsystem 3
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference 329
:TRIGger:CAN:PATTern:ID:MODE
(see page 530)
Command Syntax
:TRIGger:CAN:PATTern:ID:MODE <value>
<value> ::= {STANdard | EXTended}
The :TRIGger:CAN:PATTern:ID:MODE command sets the CAN identifier
mode. STANdard selects the standard 11-bit identifier. EXTended selects
the extended 29- bit identifier. The CAN identifier is set by the
:TRIGger:CAN:PATTern:ID command.
Query Syntax
:TRIGger:CAN:PATTern:ID:MODE?
The :TRIGger:CAN:PATTern:ID:MODE? query returns the current setting of
the CAN identifier mode.
Return Format
<value><NL>
<value> ::= {STAN | EXT}
Errors • "- 241, Hardware missing" on page 501
See Also • "Introduction to :TRIGger Commands" on page 313
• ":TRIGger:MODE" on page 319
• ":TRIGger:CAN:PATTern:DATA" on page 326
• ":TRIGger:CAN:PATTern:DATA:LENGth" on page 327
• ":TRIGger:CAN:PATTern:ID" on page 328
NOTE
This command is only valid when the automotive CAN and LIN serial decode option (Option
AMS) has been licensed.