Filter
Top Products
566 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference
9 Programming Examples
printf("Preamble YINCREMENT: %e\n", preamble[7]);
printf("Preamble YORIGIN: %e\n", preamble[8]);
printf("Preamble YREFERENCE: %e\n", preamble[9]);
*/
/* QUERY_WAVE_DATA - Outputs waveform records to the controller
* over the interface that is stored in a buffer previously
* specified with the ":WAVEFORM:SOURCE" command.
*/
viPrintf(vi, ":WAVEFORM:DATA?\n"); /* Query waveform data. */
/* READ_WAVE_DATA - The wave data consists of two parts: the header,
* and the actual waveform data followed by an New Line (NL)
* character. The query data has the following format:
*
* <header><waveform data block><NL>
*
* Where:
*
* <header> = #800002048 (this is an example header)
*
* The "#8" may be stripped off of the header and the remaining
* numbers are the size, in bytes, of the waveform data block.
* The size can vary depending on the number of points acquired
* for the waveform which can be set using the ":WAVEFORM:POINTS"
* command. You may then read that number of bytes from the
* oscilloscope; then, read the following NL character to
* terminate the query.
*/
waveform_size = WAVE_DATA_SIZE;
/* Read waveform data. */
viScanf(vi, "%#b\n", &waveform_size, waveform_data);
if ( waveform_size == WAVE_DATA_SIZE )
{
printf("Waveform data buffer full: ");
printf("May not have received all points.\n");
}
else
{
printf("Reading waveform data... size = %d\n", waveform_size);
}
}
/*
* save_waveform
* ------------------------------------------------------------------
* This function saves the waveform data from the get_waveform
* function to disk. The data is saved to a file called "wave.dat".
*/
void save_waveform(void)
{
FILE *fp;
fp = fopen("c:\\scope\\data\\wave.dat", "wb");
/* Write preamble. */
fwrite(preamble, sizeof(preamble[0]), 10, fp);