Filter
Top Products
60 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference
3 Commands by Subsystem
Command Types Three types of commands are used:
• Common (*) Commands — See "Introduction to Common (*)
Commands" on page 63 for more information.
• Root Level (:) Commands — See "Introduction to Root (:) Commands"
on page 88 for more information.
• Subsystem Commands — Subsystem commands are grouped together
under a common node of the "Command Tree" on page 535, such as the
:TIMebase commands. Only one subsystem may be selected at any given
time. When the instrument is initially turned on, the command parser is
set to the root of the command tree; therefore, no subsystem is
selected.
":SBUS Commands" on page 276 Control oscilloscope functions associated with
the serial decode bus.
":SYSTem Commands" on page 294 Control basic system functions of the
oscilloscope.
":TIMebase Commands" on page 302 Control all horizontal sweep functions.
":TRIGger Commands" on page 313 Control the trigger modes and parameters for
each trigger type.
":WAVeform Commands" on page 401 Provide access to waveform data.
Subsystem Description