94 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference
3 Commands by Subsystem
:BLANk
(see page 530)
Command Syntax
:BLANk [<source>]
<source> ::= {CHANnel<n> | FUNCtion | MATH}
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :BLANk command turns off (stops displaying) the specified channel or
math function. The :BLANk command with no parameter turns off all
sources.
See Also • "Introduction to Root (:) Commands" on page 88
• ":CDISplay" on page 95
• ":CHANnel<n>:DISPlay" on page 147
• ":FUNCtion:DISPlay" on page 184
• ":STATus" on page 119
• ":VIEW" on page 122
Example Code • "Example Code" on page 122
NOTE
To turn on (start displaying) a channel, etc., use the :VIEW command. The DISPlay
commands, :CHANnel<n>:DISPlay or :FUNCtion:DISPlay are the preferred method to turn
on/off a channel, etc.
NOTE
MATH is an alias for FUNCtion.