Filter
Top Products
Commands by Subsystem 3
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference 331
:TRIGger:CAN:SIGNal:BAUDrate
(see page 530)
Command Syntax
:TRIGger:CAN:SIGNal:BAUDrate <baudrate>
<baudrate> ::= integer in NR1 format
<baudrate> ::= {10000 | 20000 | 33300 | 50000 | 62500 | 83300 | 100000
| 125000 | 250000 | 500000 | 800000 |1000000}
The :TRIGger:CAN:SIGNal:BAUDrate command sets the standard baud rate
of the CAN signal from 10 kb/s to 1 Mb/s. If a non- standard baud rate is
sent, the baud rate will be set to the next highest standard rate.
If the baud rate you select does not match the system baud rate, false
triggers may occur.
Query Syntax
:TRIGger:CAN:SIGNal:BAUDrate?
The :TRIGger:CAN:SIGNal:BAUDrate? query returns the current CAN baud
rate setting.
Return Format
<baudrate><NL>
<baudrate> ::= integer = {10000 | 20000 | 33300 | 50000 | 62500
| 83300 | 100000 | 125000 | 250000 | 500000
| 800000 |1000000}
See Also • "Introduction to :TRIGger Commands" on page 313
• ":TRIGger:MODE" on page 319
• ":TRIGger:CAN:TRIGger" on page 333
• ":TRIGger:CAN:SIGNal:DEFinition" on page 496
• ":TRIGger:CAN:SOURce" on page 332