Filter
Top Products
392 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference
3 Commands by Subsystem
:TRIGger:UART:DATA
(see page 530)
Command Syntax
:TRIGger:UART:DATA <value>
<value> ::= 8-bit integer in decimal or <nondecimal> from 0-255
(0x00-0xff)
<nondecimal> ::= #Hnn where n ::= {0,..,9 | A,..,F} for hexadecimal
<nondecimal> ::= #Bnn...n where n ::= {0 | 1} for binary
The :TRIGger:UART:DATA command selects the data byte value (0x00 to
0xFF) for the trigger QUALifier when in UART mode. The data value is
used when one of the RD or TD trigger types is selected.
Query Syntax
:TRIGger:UART:DATA?
The :TRIGger:UART:DATA? query returns the current UART trigger data
value.
Return Format
<value><NL>
<value> ::= 8-bit integer in decimal from 0-255
See Also • "Introduction to :TRIGger Commands" on page 313
• ":TRIGger:MODE" on page 319
• ":TRIGger:UART:TYPE" on page 399