Filter
Top Products
Commands by Subsystem 3
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference 65
*CLS (Clear Status)
(see page 530)
Command Syntax
*CLS
The *CLS common command clears the status data structures, the
device-defined error queue, and the Request-for-OPC flag.
See Also • "Introduction to Common (*) Commands" on page 63
• "*STB (Read Status Byte)" on page 81
• "*ESE (Standard Event Status Enable)" on page 66
• "*ESR (Standard Event Status Register)" on page 68
• "*SRE (Service Request Enable)" on page 79
• ":SYSTem:ERRor" on page 297
NOTE
If the *CLS command immediately follows a program message terminator, the output queue
and the MAV (message available) bit are cleared.