Filter
Top Products
Language Dictionary - 3
109
INITiate:CONTinuous:SEQuence
INITiate:CONTinuous:NAME
These commands control the transient generator trigger system as follows:
1 or ON
Continuously initiates the transient trigger system.
0 or OFF
Turns off continuous triggering. In this state, the trigger system must be initiated for each
triggered event using INITiate:SEQuence.
INITiate:CONTinuous:SEQuence references the transient trigger sequence by its number, while
INITiate:CONTinuous:NAME references it by its name.
Command Syntax
INITiate:CONTinuous:SEQuence[1] <Bool>
INITiate:CONTinuous:NAME TRANsient, <Bool>
Parameters
0 | 1 | OFF | ON
Examples
INIT:CONT:SEQ ON INIT:CONT:NAME TRAN, 1
Related Commands
ABOR INIT:CONT TRIG *TRG
TRIGger
When the trigger subsystem has been initiated, the TRIGger command generates a trigger signal
regardless of the selected trigger source.
Command Syntax
TRIGger[:SEQuence1][:IMMediate]
TRIGger[:TRANsient][:IMMediate]
Parameters
None
Examples
TRIG TRIG:TRAN TRIG:SEQ1:IMM
Related Commands
ABOR TRIG:SOUR TRIG:DEL TRIG:SYNC
TRIG:SYNC:PHAS INIT INIT:CONT *TRG WAI
TRIGger:DELay
This command sets the time delay between the detection of a trigger signal and the start of any
corresponding trigger action. After the time delay has elapsed, the trigger is implemented unless the
trigger system is also waiting for a sync signal that has been specified by TRIGger:SYNChronous:PHASe.
Command Syntax
TRIGger[:SEQuence1]:DELay <NRf+>
TRIGger[:TRANsient]:DELay <NRf+>
Parameters
3-phase models: 0 to 1.07533E6 | MINimum | MAXimum
1-phase models: 0 to 4.30133E5 | MINimum | MAXimum
Unit
S
(seconds)
*RST Value
0
Examples
TRIG:DEL .25 TRIG:DEL MAX TRIG:TRAN:DEL 1
Query Syntax
TRIGger[:SEQuence1]:DELay?
TRIGger[:TRANsient]:DELay?
Returned Parameters
<NR3>
Related Commands
ABOR TRIG TRIG:SOUR TRIG:SYNC
TRIG:SYNC:PHAS INIT INIT:CONT *TRG WAI