Agilent Technologies 6814B Welding System User Manual


 
Language Dictionary - 3
73
LIST:DWELl
This command sets the sequence of list dwell times. Each value represents the time in seconds that the
output will remain at the particular list step point before completing the step. At the end of the dwell time,
the output of the depends upon the following conditions:
u If LIST:STEP AUTO has been programmed, the output automatically changes to the next point in
the list.
u If LIST:STEP ONCE has been programmed, the output remains at the present level until a trigger
sequences the next point in the list.
The order in which the points are entered determines the sequence in which they are output when a list is
triggered. Changing list data while a subsystem is in list mode generates an implied ABORt.
Command Syntax
[SOURce:]LIST:DWELl <NRf+> {,<NRf+>}
Parameters
3-phase models: 0 to 1.07533E6 | MINimum | MAXimum
1-phase models: 0 to 4.30133E5 | MINimum | MAXimum
Unit
S
(seconds)
Examples
LIST:DWEL 2.5,1.5,.5
Query Syntax
[SOURce:]LIST:DWELl?
Returned Parameters
<NR3> {,<NR3>}
Related Commands
LIST:CURR LIST:FREQ LIST:TTLT LIST:VOLT
LIST:DWELl:POINts?
This query returns the number of points specified in LIST:DWELl. Note that it returns only the total number
of points, not the point values.
Query Syntax
[SOURce:]LIST:DWELl:POINTs?
Returned Parameters
<NR1>
Examples
LIST:DWEL:POIN?
Related Commands
LIST:DWEL
LIST:FREQuency
This command sets the sequence of frequency list points. The frequency points are given in the
command parameters, which are separated by commas. The order in which the points are entered
determines the sequence in which they are output when a list is triggered. Changing list data while a
subsystem is in list mode generates an implied ABORt.
Command Syntax
[SOURce:]LIST:FREQuency[:LEVel] <NRf+> {,<NRf+>}
Parameters
refer to Specifications Table in User’s Guide
Unit
HZ
(hertz)
Examples
LIST:FREQ 55,60,65
Query Syntax
[SOURce:]LIST:FREQuency[:LEVel]?
Returned Parameters
<NR3> {,<NR3>}
Related Commands
LIST:FREQ:POIN? LIST:COUN LIST:DWEL LIST:STEP