Filter
Top Products
ACCESSORIES
C-3 C-3
Power MIG® 215XT
MAGNUM 250LX PUSH-PULL GUN
AND PUSH PULL ADAPTER
For heavier duty aluminum applications when use of large
16 pound aluminum spools of wire are desired the follow-
ing push pull gun and adapter kit are available.
Magnum 250LX Push Pull Gun (K2704-1)
This pistol grip push pull gun is similar to the Magnum
250LX spool gun except it is designed to feed large
spools of wire. The Magnum 250LX push pull features a
25 foot power, gas and control cable. It operates as an
assist slave motor pulling the aluminum wire as the Power
MIG® drive motor acts as the master push motor.
Magnum 250LX Push Pull Adapter (K2705-1)
This adapter box is designed to drive the Magnum 250LX
push pull gun when used on a non push ready Lincoln
power source feeder such as the Power MIG® 215XT or
255XT. This box features a 115V cord and plug to power
the box, a control cable with receptacle to connect the
push pull gun’s control cable to, and a 4-pin connector to
connect to the Power MIG® gun trigger receptacle.
Note the Magnum 250LX push pull gun has a wire feed
speed adjustment potentiometer. However this poten-
tiometer only functions on push-pull ready machines like
the Power MIG® 350MP. When the Magnum 250LX is
used on a non-push-pull machine with the K2705-1
adapter, the wire feed speed is set on the control panel of
the machine.
CONNECTING THE MAGNUM 250LX
PUSH-PULL GUN (K2704-1) AND
MAGNUM 250LX PUSH-PULL GUN
ADAPTER (K2705-1)
See Figure C.1
1. Plug the 115 VAC cable into available 115V AC recep-
tacle. The Power MIG
®
215XT (K2701-1) furnishes
the 15A 115V AC auxiliary supply. The receptacle is
located at the back of the machine.
2. Connect the 4-pin connector cable of the Push-Pull
Gun Adapter to the 4-pin trigger receptacle located in
the front section of the wire drive compartment.
3. Connect the 7-pin connector cable of the Push-Pull
Gun to the 7-pin receptacle cable from the adapter.
4. Connect the Push-Pull gas & power pin into the Power
MIG
®
wire feeder brass bushing.
5. Attach a gas hose from the Gas supply to the rear inlet
gas fitting on the Power MIG
®
215XT
MAKE A WELD WITH THE MAGNUM
250LX PUSH-PULL GUN
1. Power MIG
®
215XT
a. Set machine to non spool gun operation.
b. Turn the Power MIG
®
215XT input power ON.
c. Adjust the voltage control at the front panel.
d. Adjust the wire speed control on the front panel.
Refer to the procedure decal mounted at the inside
of the wire feeder compartment cover.
2. Magnum 250LX Push-Pull Gun:
a. Set machine to non spool gun operation.
b. Closing Push-Pull gun trigger starts the Push-Pull
gun welding and makes all guns connected to the
machine electrically “Hot”.
c. The Push-Pull Adapter will provide power and con-
trol to the “Pull” motor of the Push-Pull gun & the
Power MIG
®
215XT will control its wire drive.
PLUG INTO
AVAILABLE 120VAC
POWER SOURCE
7-PIN
CABLE
CONNECTORS
4-PIN
CABLE
CONNECTOR
MAGNUM 250LX
PUSH-PULL GUN
ADAPTER
FIGURE C.1
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC