Filter
Top Products
WIRE DRIVE MOTOR REMOVAL AND REPLACEMENT PROCEDURE
(continued)
1. Place the new wire drive assembly into its prop-
er position.
2. Connect plug J4.
3. Maneuver assembly back into its original posi-
tion.
4. Replace all mounting screws previously
removed.
5. Using a 3/4” nut driver, replace the thick black
lead previously removed.
6. Reconnect the gas hose to the wire drive
assembly.
7. Close case wrap around cover.
TROUBLESHOOTING AND REPAIR
F-32 F-32
Power MIG® 215XT
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC