Filter
Top Products
TROUBLESHOOTING AND REPAIR
F-26 F-26
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
RETEST AFTER REPAIR
Retest a machine:
• If it is rejected under test for any reason that requires you to remove any part which
could affect the machine’
s electrical characteristics.
OR
• If you repair or replace any electrical components.
SET UP
1. Once the repairs have been completed, the feeder must be connected to a Powerwave
455M power source.
2. Go to the Service Navigator under Diagnostic Utility and perform the calibration procedure.
3. With the use of a load bank and the utility, all functions of the feeder can be tested.