Filter
Top Products
POWER FEED 10M SINGLE/DUAL
ACCESSORIES
CC-5 CC-5
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
K1500-4 (MILLER CONNECTION)
For any gun having a newer style Miller connector.
Install gun adapters per the instructions shipped with it.
K1500-5 (OXO CONNECTION)
For any gun having an OXO style connector. Install
gun adapters per the instructions shipped with it.
CONDUIT ADAPTERS
K1546-2 ADAPTER
for use with Lincoln Magnum conduit and E-Beam con-
duit (wire sizes 1/16 - .120)
For Magnum conduit:
Install the K1546-2 gun adapter at the incoming end of
the feed plate, secure with the set screw located at the
back of the feed plate. If a brass fitting is supplied with
the conduit, remove it from the feeder end of the con-
duit by unscrewing it. Insert the conduit into the K1546-
2, secure the conduit by fastening it the the adapter
with the supplied knob screw.
For E-Beam Conduit:
Install the K1546-2 gun adapter at the incoming end of
the feed plate, secure with the set screw located at the
back of the feed plate. Insert the conduit into the
K1546-2, secure the conduit by fastening it the the
adapter with the supplied knob screw.
DUAL PROCEDURE SWITCH
OPTIONS
K683-3 DUAL PROCEDURE SWITCH
Kit includes gun switch, and mountings for Lincoln
Innershield and Magnum guns, with 15 ft. (4.5m) con-
trol cable and 5-pin plug with two leads to connect to
gun trigger.
Connect the 5-pin plug of the K683-3 Dual procedure
Switch to the Power Feed 10 Dual Wire Feeder
Trigger/Dual Procedure 5-socket receptacle.
The two lead plug cord extending out of the 5-pin plug
of the Dual Procedure switch is to be connected to the
two trigger leads of the welding gun per instructions
shipped with the kit.
K683-1 DUAL PROCEDURE SWITCH
The K683-3 Dual Procedure Switch is the recommend-
ed method of obtaining dual procedure for non-Fast-
Mate guns; but a K683-1 can be used. For using a
K683-1 with a fast mate gun, see USING DUAL PRO-
CEDURE WITH FAST-MATE GUNS. A K683-1 Dual
Procedure Switch can be used on the Power Feed 10
Dual if a K686-2 adapter is used. The K686-2 kit
includes the gun switch and mountings for Lincoln
Innershield and Magnum guns, with 15 ft. (4.5 m) con-
trol cable and 3-pin plug. K686-2 Adapter permits the
3-pin plug from the K683-1and 5-pin gun trigger plug to
be connected to the 5-pin trigger/dual procedure
receptacle on the wire feeder.
USING DUAL SCHEDULE WITH FAST-
MATE GUNS ON -10 SERIES FEEDERS
Configuration 1
K489-7 Dual Schedule Fast-Mate adapter
K575-[ ] Magnum 400 DS/FM gun (or competitive
DS/FM gun)
Configuration 2
*
K489-7 Dual Schedule Fast-Mate adapter
K683-1 Dual Procedure Switch (3 pin)
K686-2 "Y" adapter (3pin + 5 pin to 5 pin)
* Non-DS Fast-Mate gun (Magnum 450WC, Magnum 200, Magnum 300,
Magnum 400, and others)
K590-6 WATER CONNECTION KIT
Install per the instructions shipped with the kit.
K1536-1 WATER FLOW SENSOR KIT
Install per the instructions shipped with the kit