Filter
Top Products
OPERATION
POWER FEED 10M SINGLE/DUAL
B-4 B-4
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
PROCESS LIMITATIONS
The Power Feed 10M Single Wire Feeder is not suit-
able for:
• SAW
• GT
AW with HF
The MSP4 does not support "Spot" welding.
Not all weld modes or processes described in this manual are avail-
able on all Power Wave power sources.
REQUIRED EQUIPMENT
Lincoln’s Power Feed 10M Single Wire Feeder is
designed for use with the Power Wave family of power
sources. These include:
• Power Wave 355 • Power Wave 455M CE
• Power Wave 455 • Power Wave 455M STT
• Power Feed 455/STT • Power Wave 455M STT CE
• Power Wave 455M • Power Wave 655
ADDITIONAL REQUIRED EQUIPMENT
• Drive Roll Kits
• Control Cables
• Gun and Cable Assembly
• Weld Wire
• Shielding gas
• Work Cable and Clamp
EQUIPMENT LIMITATIONS
• The Power Feed 10M Single Wire Feeder does
not
operate with the Power Wave 450.
• The Power Feed 10M Single Wire Feeder does not
operate with any analog based power sources (CV-
xxx machines, DC-xxx machines, etc.)
• The Memory Panel is required to set procedure limits.
• The Boom model does not support push-pull guns or
GTAW welding.
• A push-pull gun and foot amptrol may not be plugged
into the Power Feed 10M Single Wire Feeder at the
same time.