Filter
Top Products
POWER FEED 10M SINGLE/DUAL
OPERATION
B-19 B-19
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
ARC FORCE
(Soft)-10.0 to
(Crisp)+10.0
DESCRIPTION
Arc Force adjusts the short cir-
cuit current for a soft arc, or for
a forceful, driving arc. It helps to
prevent sticking and shorting
organic coated electrodes, par-
ticularity globular transfer types
such as stainless and low
hydrogen. Arc Force is espe-
cially effective for root pass on
pipe with stainless electrode
and helps to minimize spatter
for certain electrodes and pro-
cedure as with low hydrogen,
etc.
START TIME:
0 to 10 seconds
FUNCTION
If no remote control is installed,
this control sets the time for the
weld output to ramp up or down
from a preset Start current to
the preset Weld current. Use
the WFS/AMP knob to adjust
Start current while the Start
Options LED is displayed.
START OPTIONS
No arc ending options are active for SMAW (Stick)
welding modes.
END OPTIONS
ARC CONTROL
194
0
WFS AMPS
VOLTS TRIM
LESS
AMPS
MORE
AMPS
OUTPUT
OFF
OUTPUT
ON
Material
Steel
Steel
PROCESS
Stick Soft(7018)
Stick Crisp(6010)
MODE
1
2
MACHINE FUNCTIONALITY BY WELD PROCESS
CC-STICK
Use the following tables to review how the machine functions (output controls, arc control, Start options and weld
options) for the weld modes listed in the top table.
OUTPUT CONTROL KNOBS
CC STICK MODES