Filter
Top Products
B-3 B-3
V205-T AC/DC
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
OPERATION
REAR CONTROL PANEL (FIGURE B.1)
• I1: Off/On switch turns on the electric power to
the welder. It has two positions, "O" off, and
"I" on.
------------------------------------------------------------------------
* With "l1" in the "I" (ON) position, the welding machine
is operational and there is voltage between the posi-
tive (+) and negative (-) Terminals in stick welding. In
TIG, the welding process needs a trigger closure
command at the remote control connection.(Usually
via an Arc Start Switch or Foot Amptrol)
* The welder is connected to the supply even if the “l1”
(Power Switch) is in the "O" (Off) position, and there-
fore there are electrically live parts inside the power
source. Carefully follow the instructions given in this
manual.
FIGURE B.1
* 1 : Supply cable
* 2 : Gas attachment
l1 : Power Switch
WARNING