Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TROUBLESHOOTING & REPAIR
F-28 F-28
V205-T AC/DC
BUS BOARD TEST (continued)
TEST PROCEDURE
1. Remove input power to the V205-T machine.
2. Using a phillips head screwdriver, remove the
case wraparound cover.
3. Perform the Capacitor Discharge
Procedure detailed earlier in this section.
4. Locate the Bus board and associated plugs .
Do not remove plugs from the board. See
Figure F.11.
5. Carefully apply the correct input voltage to
the V205-T and check for the correct volt-
ages per Tables F.5, F.6, F.7, F.8 & F.9
6. Machine should be set to “STICK” mode.
FIGURE F.11 BUS BOARD LOCATION
BUS BOARD