Filter
Top Products
11
ASSEMBLY INSTRUCTIONS
WARNING: MAKE SURE THE SAW IS SECURELY ATTACHED TO THE STAND BEFORE PERFORMING ANY
CUTTING OPERATIONS. DO NOT OPERATE THIS MACHINE UNTIL YOU READ AND UNDERSTAND THE
ENTIRE INSTRUCTION MANUAL.
Fig. 8
Fig. 9
Fig. 10
ASSEMBLING SAW STAND
1. Assemble the dust chute and support panel (A)
Fig. 8, to the inside of the front stand panel (B) with three
#10 x 1/2″ sheet metal screws (C).
2. Insert four #10-32 x 1/2″ screws (D) Fig. 9 through
support panel and dust chute. Install four #10-32 hex
nuts (E) Fig. 9. NOTE: The front stand panel will have the
saw identity labels facing you. Do not completely tighten
the stand hardware at this time. Also, make certain the
dust chute/support panel (A) Fig. 9, is located under the
lip of front stand panel (B).
3. Assemble the other end of dust chute and support
panel (A) Fig. 10, to rear stand panel (F) as shown with
four #10-32 x 1/2″ screws and #10-32 hex nuts, which
are shown at (C). NOTE: Do not completely tighten stand
hardware at this time.
B
A
A
B
A
C
C
F
Fig. 11
ASSEMBLING
SAW TO STAND
1. Turn saw table face down on a piece of cardboard
to protect the table surface. Place stand (B) Fig. 11, onto
saw (A). Align eight holes in the stand (B) with mounting
holes in the saw (A) and fasten with eight 5/16"-18 screws,
flat washers, lockwashers, and hex nuts one of which is
shown at (C) Fig. 11. Assemble flat washers onto
screws, place screws through holes, assemble
lockwashers then hex nuts finger tight. Do not
completely tighten hardware at this time.
2. Install four rubber feet (D) Fig. 11, on the end of each
stand leg (B).
3. Turn saw table face up.
C
A
B
C
C
E
D
D