Filter
Top Products
29
Fig. 87
11. After the holes have been drilled in the edge of the front and rear extension
table board, fasten both front and rear rail to table using the 1-1/2″ flat head
Phillips screws (T) Fig. 87, 1-1/4″ O.D. flat washers (U) and hex nuts (V). NOTE:
The 1-1/4″ flat washer cannot be used on the end holes (X) shown covered by
clamp.
12. Lay the guide tube (B) Fig. 88, on the saw table,
and line up the threaded holes (C) on bottom of guide
tube (B) with the through-holes (D) on the front rail (A) in
seven places.
13. Position the guide tube (B) Fig. 89 on the front rail
and fasten the guide tube to the rail using the 1/4-20 x
1/2″ long hex head screws (G) and lockwashers in
seven places. Place lockwasher onto screw and
assemble into rail.
Fig. 88
Fig. 89
B
G
B
A
C
D
T
U
V
X