Filter
Top Products
46
LUBRICATION
1. Apply household floor paste wax to fence and guide
tube sliding surfaces weekly. Also, saw table and
extension table surface should be waxed often.
2. Apply grease to cam lock (A) Fig. 149, and cam foot
(B) occasionally to prevent wear.
Fig. 149
ADJUSTING CLAMPING ACTION OF FENCE
LOCKING HANDLE
When the fence locking handle (A) is pushed to the down position, (Fig. 147), the fence assembly (B) should be
completely clamped to the guide tube (C). If the fence assembly (B) is not completely clamped to the guide tube (C)
when the handle (A) is pushed down, as shown in Fig. 147, lift up handle (A) and raise fence assembly (B) up off the
guide tube (C). Slightly tighten the two adjusting screws (D) and (E) Fig. 148, using the 3/16″ allen wrench (F) not
supplied. Adjusting screws (D) and (E)
Fig. 148, should be tightened an equal amount
. Replace fence onto the
guide tube and re-check to see if the fence assembly (B) Fig. 147 is completely tightened to the guide tube (C) with the
locking handle (A) pushed down. Adjust further if necessary. IMPORTANT: AFTER ADJUSTING THE CLAMPING
ACTION OF THE FENCE LOCKING HANDLE, CHECK TO SEE IF THE FENCE IS PARALLEL TO THE MITER
GAGE SLOT AND ADJUST IF NECESSARY.
Fig. 146
Fig. 147
Fig. 148
F
D
E
B
C
A
D
E
F
B
A