Filter
Top Products
38
COMMON SAWING OPERATIONS
CROSS-CUTTING
Cross-cutting requires the use of the miter gage to
position and guide the work. Place the work against the
miter gage and advance both the gage and work toward
the saw blade, as shown in Fig. 120. The miter gage
may be used in either table slot. When bevel cutting
(blade tilted), use the table groove that does not cause
interference of your hand or miter gage with the saw
blade guard.
Start the cut slowly and hold the work firmly against the
miter gage and the table. One of the rules in running a
saw is that you never hang onto or touch a free piece of
work. Hold the supported piece, not the free piece that
is cut off. The feed in cross-cutting continues until the
work is cut in two, and the miter gage and work are
pulled back to the starting point. Before pulling the work
back, it is good practice to give the work a little
sideways shift to move the work slightly away from the
saw blade. Never pick up any short length of free work
from the table while the saw is running. Never touch a
cut-off piece unless it is at least a foot long.
For added safety and convenience the miter gage can
be fitted with an auxiliary wood-facing (C), as shown in
Fig. 121, that should be at least 1 inch higher than the
maximum deth of cut, and should extend out 12 inches
or more to one side or the other depending on which
miter gage slot is being used. This auxiliary wood-facing
(C) can be fastened to the front of the miter gage by
using two wood screws (A) through the holes provided
in the miter gage body and into the wood-facing.
Common sawing operations include ripping and cross-cutting, plus a few other standard operations of a
fundamental nature. As with all power tools, there is a certain amount of hazard involved with the operation and
use of the machine. Using the machine with the respect and caution, demanded as far as safety precautions are
concerned, will considerably lessen the possibility of personal injury. However, if normal safety precautions are
overlooked or completely ignored, personal injury to the operator can result.
NOTE: THE USE OF ATTACHMENTS AND ACCESSORIES NOT RECOMMENDED BY DELTA MAY RESULT IN
THE RISK OF INJURY.
Fig. 120
Fig. 121
C
A
A
PROTECTING CAST IRON TABLE FROM RUST
To clean and protect cast iron tables from rust, you will need the following materials: 1 pushblock from a jointer, 1 sheet
of medium Scotch-Brite™ Blending Hand Pad, 1 can of WD-40
®
, 1 can of degreaser, 1 can of TopCote
®
Aerosol. Apply
the WD-40 and polish the table surface with the Scotch-Brite pad using the pushblock as a holddown. Degrease the
table, then apply the TopCote
®
accordingly.