Filter
Top Products
18
Fig. 35
Fig. 36
Fig. 37
Fig. 38
9. With the blade guard (L) Fig. 35, in the raised
position, assemble the saw blade (K) on the saw arbor
with two arbor wrenches supplied.
10. Use a straight edge to check to see if the saw blade
is aligned with the rear of the splitter (G) in Figs. 36 and
37. If alignment is necessary, loosen the screws (A) Fig.
37, align splitter (G) with the saw blade, and tighten two
screws (A).
11. Lower saw blade and install table insert (P) Fig. 38,
in the saw table. IMPORTANT: When installing the table
insert, make certain to hold on to the blade guard (L).
The insert will automatically release the holding action
on the splitter and lower the blade guard when it is
installed in the table opening.
L
K
G
G
A
L
P