Filter
Top Products
12
MOTOR
The motor shipped with your saw is a 1-1/2 H.P. at 115 volts or 2 H.P. at 230 volts, Ball Bearing,
Capacitor Start/Capacitor Run motor.
This motor has been especially selected to best supply power to your machine, and the relative safety
of the machine is enhanced by its use. Use only this motor, as the use of other motors may be
detrimental to the performance and safety of the saw.
Fig. 15
ASSEMBLING MOTOR TO
MOTOR MOUNTING PLATE
WARNING: WHEN ASSEMBLING THE MOTOR TO
THE MOTOR MOUNTING PLATE, MAKE CERTAIN THE
MACHINE IS DISCONNECTED FROM THE POWER
SOURCE.
1. Assemble the motor (A) to the motor mounting plate
(B) as shown in Fig. 15, using four 5/16-18 carriage
bolts, flat washers, star washers, and hex nuts (C).
Assemble star washers on bolts, place bolts through
holes, then assemble lockwashers and hex nuts.
NOTE: Do not completely tighten the hex nuts at this
time.
A
C
B
Fig. 13
Fig. 14
ASSEMBLING BLADE
TILTING HANDWHEEL
1. Attach blade tilting handwheel (A) Fig. 13 to shaft
(B). Make certain slot (C) in handwheel is engaged with
roll pin (D) on the shaft.
2. Thread locking lever (E) Fig. 14, on shaft.
3. Fig. 14 illustrates the blade tilting handwheel (A) and
locking lever (E) assembled to the saw.
D
B
A
C
A
E