Filter
Top Products
15
Fig. 23
Fig. 24
Fig. 25
Fig. 26
7. Lift the motor and assemble the drive belt (H) Fig. 23
to the arbor pulley and motor pulley (B). The weight of
the motor will provide the correct belt tension.
8. WARNING: IMMEDIATELY AFTER ASSEMBLING
THE BELT, RAISE THE SAW BLADE TO ITS MAXIMUM
HEIGHT AND TILT THE SAW BLADE TO 45 DEGREES.
CHECK TO SEE IF THE MOTOR (J) FIG. 24 IS BELOW
THE TOP OF THE TABLE SURFACE (K). IF THE
MOTOR (J) IS ABOVE THE TOP OF THE TABLE
SURFACE, MOVE THE MOTOR TO THE LEFT UNTIL
THE END BELL (J) OF THE MOTOR IS BELOW THE
TOP OF THE TABLE SURFACE. THEN RE-ALIGN THE
MOTOR PULLEY TO THE ARBOR PULLEY.
9. Assemble the outer cover (E) Fig. 25, of the belt and
pulley guard assembly, which was removed in STEP 3,
and fasten with external tooth lockwasher and wing nut
(D). IMPORTANT: Make certain the outer cover does not
interfere with the drive belt and the motor pulley.
CONNECTING MOTOR CORD
TO SWITCH ASSEMBLY
WARNING: BEFORE CONNECTING MOTOR CORD
TO THE SWITCH ASSEMBLY, MAKE CERTAIN THE
MACHINE IS DISCONNECTED FROM THE POWER
SOURCE.
1. Insert the pronged motor plug (A) Fig. 26, into the
female receptacle (B) of switch-to-motor cord (C).
H
B
K
J
D
E
C
B
A