Filter
Top Products
14
Fig. 19
Fig. 20
Fig. 21
Fig. 22
ASSEMBLING MOTOR
PULLEY, BELT AND
PULLEY GUARD, AND
DRIVE BELT
WARNING: WHEN ASSEMBLING MOTOR
PULLEY, BELT AND PULLEY GUARD, AND DRIVE
BELT, MAKE CERTAIN THE MOTOR IS
DISCONNECTED FROM THE POWER SOURCE.
1. Remove the motor shaft key that is taped to the
motor.
2. Insert the key (A) Fig. 19 in the keyway on the motor
shaft. Assemble the motor pulley (B) on the motor shaft
with the hub of the pulley facing out. Tighten set screw
(C).
3. Remove wing nut and external tooth lockwasher (D)
Fig. 20, and outer cover (E) from belt and pulley guard (G).
4. Slide the belt and pulley guard bracket (G) Fig. 21
between the motor plate (M) and motor mounting plate
(L), as shown.
5. Position belt and pulley guard bracket (G) Fig. 22, so
that the motor pulley (B) is centered and through the
hole in the belt and pulley guard bracket.
6. Use a straight edge to align the motor pulley with the
arbor pulley. If necessary, adjust the motor pulley (B)
Fig. 22 in or out on the motor shaft. Tighten the four hex
nuts [refer back to (C) Fig. 15] that fasten the motor to
the motor mounting plate.
B
A
C
G
D
E
M
L
G
G
B