Filter
Top Products
27
Fig. 81
6. If the accessory right extension table for use with the T-Square
®
fence was
not purchased, construct an extension table by following the dimensions shown
in Fig. 81.
Fig. 79
Fig. 80
3. Using the template (D) Figures 78 and 79, check and adjust front rail at both ends of the saw table to make sure
rail (A) is level with table surface. Tighten rail mounting hardware (B). IMPORTANT: Template (D) must be on saw
table when checking, not on extension wing.
4. Assemble rear rail (E) Fig. 80 to rear of saw table using the two 3/8-24 x 1-1/4" long hex head screws (F), 7/8" flat
washers, 3/8-24nuts and 3/8" lockwashers (not shown). Place flat washer on bolt, then assemble bolt into rear rail, then
assemble lockwasher and nut.
5 Make certain top edge of rail (E) Fig. 80 is below table surface, and that top edge of cut-outs (G) are below miter
gage slots before tightening screws (F).
D
A
B
E
F
G