Filter
Top Products
16
Fig. 27
Fig. 28
Fig. 29
Fig. 30
2. Fig. 27, illustrates the motor cord connected to the
switch assembly.
ASSEMBLING
BLADE GUARD AND
SPLITTER ASSEMBLY
WARNING: DISCONNECT MACHINE FROM
POWER SOURCE.
1. Fasten the rear splitter mounting bracket (A) Fig. 28,
to the rear trunnion using the two 1/4-20 x 3/4″ hex head
screws (B) and flat washers. Do not completely tighten
the two screws (B) at this time.
2. Raise saw arbor to its highest position. With
wrenches supplied, remove the saw blade from the saw.
Refer to section “CHANGING THE SAW BLADE” of this
manual.
3. Remove screw and large washer (C) Fig. 29, from
the inside splitter mounting bracket.
4. Use a straight edge to check to see if the top and
bottom of the inside splitter bracket (D) Fig. 30 is aligned
with the inner arbor flange (E).
B
A
C
D
E