Filter
Top Products
20
UNIFENCE ASSEMBLY INSTRUCTIONS
Fig. 43
ASSEMBLING TABLE
BOARD TO SAW
1. Lay the table board upside down on the floor or
bench, Fig. 44.
2. Assemble the two table legs (A) Fig. 45 to the
bottom of the table using eight #8 x 3/4″ self tapping
wood screws. NOTE: Refer to Fig. 43 for the hole
location for the 30″ Unifence table legs.
3. Insert foot adapter (T) Fig. 46, into the bottom of
each leg (A). Assemble the 3/8″ jam nut (V)
Fig. 46, approximately 3/4 of the way onto leveling
screw (W). Thread the leveling screw (W) Fig. 46 into
foot adapter. Fig. 47 illustrates the foot leveling
assembly on the table leg. Assemble the remaining
foot assembly to the other table leg in the same
manner. NOTE: Height adjustments can be made
later.
Fig. 44
Fig. 45
A
Fig. 47
Fig. 46