Filter
Top Products
36
Fig. 112
Fig. 113
Fig. 114
Fig. 115
4. To move the fence along the guide rail, simply lift up
clamp lever (A), Fig. 112, slide fence to desired position
on the rail, and push down on clamp lever (A) to lock
fence in place.
5. The distance the fence is positioned away from the
blade is indicated by the two witness lines (B) and (C) Fig.
113, located on the cursor (D). The witness lines (B) and
(C) indicate the distance the fence is positioned away
from the saw blade. Witness line (B) indicates the
distance the fence is away from the blade when the fence
is in the horizontal position (Fig. 111), and witness line (C)
indicates the distance the fence is away from the blade
when the fence is in the vertical position (Fig. 110). To
adjust cursor (D), make a test cut with the fence in either
the vertical or horizontal position, measure the distance
of the finished cut and move the cursor (D) by loosening
the two screws (E) Fig. 113. After adjustment is
completed, tighten the two screws (E).
6. To remove the fence and fence body assembly (F)
Fig. 114, from the guide rail, lift up on fence clamping
lever (A) and turn lever (A) to the CCW indent position.
The fence assembly (F) can then be pulled straight off
the guide rail and removed, as shown in Fig. 114.
ADJUSTING FENCE
PARALLEL TO
MITER GAGE SLOTS
The fence (A) Fig. 115, should be adjusted so it is parallel
to miter gage slots (B). To check and adjust, move the
fence (A) until the bottom front edge of the fence is in line
with the edge of the miter gage slot, and push down on
fence clamping lever (C). Check to see that the fence is
parallel to the miter gage slot the entire length of the
table. If the rear of the fence must be moved, slightly
tighten or loosen one of the adjustment plugs (D) or (E)
Fig. 115, using the arbor wrench or 7/8″ wrench, until the
fence is parallel with the miter gage slot. IMPORTANT:
DO NOT OVERTIGHTEN ADJUSTMENT PLUGS (D)
AND (E) FIG. 115. VERY LITTLE MOVEMENT OF THESE
ADJUSTMENT PLUGS IS NECESSARY WHEN
ADJUSTING THE FENCE PARALLEL WITH THE
MITER GAGE SLOT.
A
E
D
E
B
C
A
A
B
E
C
D
F