Filter
Top Products
25
Fig. 71
Fig. 72
Fig. 73
Fig. 70
C
E
F
B
D
A
A
B
G
G
B
B
A
ASSEMBLING CURSOR
TO UNIFENCE BODY
1. Remove two screws and flat washers (A) Fig. 68, and
assemble the cursor (B) to the Unifence body (C).
Replace the two screws and flat washers (A).
2. Fig. 69 illustrates the cursor (B) assembled to the
Unifence body. Final adjustment to the cursor (B) will be
made later.
ASSEMBLING UNIFENCE
BODY TO GUIDE RAIL
1. Turn fence body (A) Fig. 70, upside down and lay it on
a table or bench. Push handle (B) in against fence body.
Make certain the surface (C) of clamp bracket is parallel
to the face (D) of the fence body, and that the inside edge
(E) of the clamp bracket is parallel to surface (F) of the
fence body. Turn handle (B) Fig. 70, if necessary.
2. Place fence body (A) Fig. 71, onto the guide rail,
making sure that the clamp bracket is inserted into
channel (G) on rail. Notice that the clamp handle (B) is
turned to the left indent position.
3. Turn handle (B) Fig. 72, to the right indent position.
This action will prevent fence clamp from sliding out of
the channel (G).
4. Lock fence body (A) to the guide rail by pushing
down on handle (B) Fig. 73.
Fig. 69
Fig. 68
C
B
A
B