Filter
Top Products
9 - 4
The engine scans until a bar code has been read or until the deactivate com-
mand is sent. The engine can also be set to turn itself off after a specified time
has elapsed (see Read Time-Out, which follows).
Read Time-Out
Use this selection to set a time-out (in milliseconds) of the engine’s external
trigger when using serial commands to trigger the engine. Once the
engine has timed out, you can activate the engine either by the external
trigger or using a serial trigger command. After scanning the Read Time-
Out bar code, set the time-out duration (from 0-300,000 milliseconds) by
scanning digits on the Programming Chart inside the back cover, then
scanning Save.
Default = 30,000 ms.
Resetting the Standard Product Defaults
If you aren’t sure what programming options are in your engine, or you’ve
changed some options and want the factory default settings restored, scan the
Standard Product Default Settings bar code below.
The charts on the following pages list the factory default settings for each of the
commands (indicated by an asterisk (*) on the programming pages).
Read Time-Out
Standard Product Default Settings