Filter
Top Products
10 - 2
If the engine reads a bar code, but the data is not displayed correctly on the
host screen:
• The engine may not be programmed for the appropriate terminal
interface.
For example, you scan “12345” and the host displays “@es%.”
Reprogram the engine with the correct Plug and Play bar code. See
Programming the Interface beginning on page 2-1.
• The engine may not be programmed to output your bar code data
properly.
For example, you scan “12345” and the host displays “A12345B.”
Reprogram the engine with the proper symbology selections. See Chapter
6.
The engine won’t read your bar code at all.
1. Scan the sample bar codes in the back of this manual. If the engine
reads the sample bar codes, check that your bar code is readable.
Verify that your bar code symbology is enabled (see Chapter 6).
2. If the engine still can’t read the sample bar codes, scan All Symbologies
On, page 6-1.
If you aren’t sure what programming options have been set in the engine,
or if you want the factory default settings restored, refer to Setting Custom
Defaults on page 1-4.