Filter
Top Products
3 - 10
Character Activation Mode
You may use a character sent from the host to trigger the engine to begin scan-
ning. When the activation character is received, the engine continues scanning
until either the Character Activation Laser Timeout (page 3-11), the deactiva-
tion character is received (see Deactivation Character on page 3-11), or a bar
code is transmitted. Scan the following On bar code to use character activation,
then use Activation Character (following) to select the character you will send
from the host to start scanning.
Default = Off.
Activation Character
This sets the character used to trigger scanning when using Character
Activation Mode. On the ASCII Conversion Chart, page A-3, find the hex
value that represents the character you want to use to trigger scanning.
Scan the following bar code, then use the Programming Chart to read the
alphanumeric combination that represents that ASCII character. Scan
Save to finish.
End Character Activation After Good Read
After a bar code is successfully detected and read from the engine, the
laser can be programmed either to remain on and scanning, or to turn off.
When End Character Activation After Good Read is enabled, the laser
* Off
On
Activation Character